Temperature sensor for IBEX brushless controller
Programmable temperature sensor for IBEX controller.
Temperature range -10 to +125°C
Application 1
HT125ID is a small temperature sensor that supports several telemetry protocols.
It can be used to measure the temperature of the electric motor, batteries or other components of your model.
Features:
- Small dimensions
- the sensor is connected directly to the telemetry port of the receiver
- Temperature min/max values are recorded
- Automatic telemetry detection: Duplex EX, Hott, MSB, S.Bus2
- Configurable high temperature alarms
- Configuration via the transmitter
- Firmware updates.
- Configurable telemetry slots in S.Bus2 telemetry mode.
- Use the MAV Manager software to change.
- After changing the slot, select the sensor type "T125" the corresponding slot in your Futaba
- corresponding slot in your Futaba transmitter
Application 2
The HT 125ID temperature sensor is compatible with the IBEX controller series
The sensor is connected directly to input "A" of the IBEX controller. (see picture above). From this moment on, the IBEX controller knows the basic motor parameters (minimum acceleration, recommended timing, gear ratio, number of poles...) and the motor temperature. Some parameters are adjusted automatically (gear ratio, poles), the other settings are configured after resetting the controller to factory settings.
Some motor brands (e.g. Hemotec) have this temperature sensor HT125ID built in. These transmit the most important parameters to the IBEX controller and thus protect the drive train from overload or destruction - also with temperature monitoring.
The HT125ID is programmed via a Jeti Box, Smart Box or via Jetibox emulation.
Delivery includes :
- HT125ID with connector JR system cable length 30cm
- Patch cable JR -> JST (Ibex connection) 15cm
Version history:
Version 1.03 :
Configurable telemetry slots in S.Bus2 telemetry mode. Use the MAV Manager software to make changes
After changing the slot number, select the sensor type "T125" on the corresponding slot in your Futaba transmitter
PC configuration support with the MAV Manager software has been implemented. Use MAV Manager version 1.6.0 or higher
Version 1.02 : Base version
