D-Power
DPETV200V2
In 2018, D-Power launched its first fully GRP gliders on the market with the E-TERNITY series. Following its great success, the successor series is now available: E-TERNITY² - now in the ARF+ version with a significantly higher degree of prefabrication. In addition, the E-TERNITY² now comes in a new, uniform, stylish color design.
All-rounder flying characteristics
The E-TERNITY² V200 has outstanding all-round characteristics thanks to its aerodynamic design and modified wing profile. The V-tail gives the electric glider maximum stability and neutral flight characteristics. The model can be maneuvered stably through all common aerobatic manoeuvres and also cuts a very fine figure in thermals. With the top-hinged flaps, the E-TERNITY² can also be flown very slowly and landed safely.
High-quality construction
The E-TERNITY² V200 is made from a GRP fuselage painted in the mold. The wings and V-tail are also made entirely of GRP. In addition, components with particularly high loads are reinforced with carbon. The built-in MULTIlock® wing locking system provides additional support for the wings and the built-in MPX high-current connectors allow the wings to be removed quickly.
High level of ARF+ prefabrication
Spend minimum time in the workshop and maximum time on the flying field. The ARF+ degree of prefabrication takes the most time-consuming work off your hands. This is because all cable layers are completely routed so that electronic components only need to be connected to the completed wiring harness and the receiver. In addition, all control horns are pre-installed, the GRP motor bulkhead for the geared motors is resin-bonded and the battery board and servo holder are factory-fitted. The construction is therefore almost limited to the installation of your preferred electronics.
Features
ARF+ features :
Technical data :
Required accessories :